4
1
Security instructions and restriction of liability
1.1
Sign for security instructions
Security instructions for personal safety are marked with this sign and are printed in bold letters.
Instructions that refer to the functioning safety of the system are also printed in bold letters.
1.2
General safety instructions
For your own safety please note the following for installation:
Please see that fire safety cable systems and similar things are not impaired!
The controller must not be installed and used in moist areas (e. g. bathrooms) or in rooms in which
flammable gas mixtures (by gas bottles, paint, solvents etc.) are likely to occur!
Do not store any of the above and similar things in rooms where the solar controller is installed!
The controller must not be installed on a conductive base!
Use well-isolated tools only!
Do not use technical equipment that is defective or broken!
The construction safety measures can deteriorate if the controller is used in a way other than the one
determined by the manufacturer.
The preset signs and marks must not be changed, removed or made illegible.
All operations must be conducted in accordance with the national electricity regulations and local
rules!
For installation in foreign countries please see your corresponding institutions for information on
regulations and safety measures.
Keep children away from electronics!
1.3
Regarding these instructions
These operating instructions describe the functioning and installation of a controller for thermal solar
systems for feeding solar heat into a water or buffer store.
For the installation of the other components such as the solar collectors, pump group and the storage
basins please follow the corresponding installation instructions of the manufacturer.
Before starting operation read the paragraph "installation and operation" no. 5 and make sure that all
measurements have been prepared before.
Only begin with the installation when you have understood this instruction and proceed in sequence!
These instructions must be handed out to all persons that work with this system.
These instructions are part of the system controller and must be handed over in case the controller is
sold.
1.4
Restriction of liability
The manufacturer cannot monitor the compliance with these instructions or the circumstances and
methods used for installation, operation, utilization and maintenance of this controller.
Improper installation can cause damages to material and persons.
This is the reason why we do not take over responsibility and liability for losses, damages or cost that
might arise due to improper installation, operation or wrong utilization and maintenance or that occur
in some connection with the afore-mentioned.
Moreover we do not take over liability for patent infringements or infringements - occuring in
connection with the use of this controller - on third parties´ rights.
The manufacturer preserves the right to put changes to product, technical data or installation and
operation instructions without prior notice.
NOTE: Opening the device – connecting case excluded – as well as other use than determined
by the manufacturer leads to a loss of warranty.
