Steca Power Tarom 2070, Инструкция по установке и эксплуатации

Страница: 24 / 28

system sly. Please
note the following notes f
battery: the battery terminals (A+ and A ) of all regulators are connected to the same battery
each PowerTarom on or
ding is allowed b en the sev
connect the L terminals between .
grounding: only the + terminals of different PowerTaroms can be connected or grounded. Never
d the M or L to the battery minus!
of the PowerTaroms:
Tarom #1
set regulation to “voltage” (menu conf/regulation/voltage)
set electrolyte type corresponding to your battery (menu conf/electrolyte/fixed|liquid)
Tarom #2, 3, ..
“voltage” (menu conf/regulation/voltage)
ger TarCom: The TarCom logger can communicate to a single PowerTarom only. So the
f the other PowerTarom use for each PowerTarom a
several TarCom or you install instead a HS200 current sensor in the battery main line.
ensor HS200: If you ts going in and
out the battery are calculated and displayed at this PowerTarom and his TarCom logger. You
only need one HS200 for the whole system. Currents higher than the maximum of 200A will not
layed but do not harm with Tarom #1 you
can reset its configuration menu/regulation to
receiver PA15: only one PowerTarom may supply the radio signals for the PA15 receivers. Set the
“accu” at Tar ll other PowerTaroms
10 Hints for the usage of multiple PowerTaroms
In a photovoltaic several PowerTarom regulators can charge a battery simultaneou
or an optimal installation:
modules: needs dividual, ate modul p. No c an in
eral M
separ e grou onnecti
groun etwe terminals.
severa rTaroms load: do not l Powe
connect or groun
Configuration
set regulation to
accessories:
data log
currents data o s are not registrated. You can
current s attach a HS200 to the main battery cable, all curren
be disp the sensor. If you use a HS200 sensor together
“SOC”.
“option transmit” to
in the system. om #1 and set “option transmit” to “off”at a
24