Steca Power Tarom 2070, Инструкция по установке и эксплуатации

Страница: 15 / 28

15
xample Of Configuration (chapter 6.7, page 17) describing how to proceed.
long
0V...29,0V | 52,0V...58,0V
is
nd
0...05:00 : 13,5V...15,0V | 2 ,0V.
ing.
,
he
c
This window is d
es for programming: in the period from 14,0V...15,5V | 28,0V...31,0V | 56,0V...62,0V
E
The end of charge “float” voltage serves for maintaining the charge in the battery for
periods and preventing self-discharge. This voltage should not be too high, since this
may lead to permanent gassing, which damages the battery. Maximum values are stated on the battery
data sheet of your battery. For most types of lead battery, this float value is 13.7 volts.
possibilities for programming: 13,0V...14,5V | 26,
Increasing the charge voltage over a limited period of time (boost or “bulk” charging)
not harmful for lead battery types, if within certain parameters. Maximum values are
stated on the battery data sheet. Within this window, both the boost charge voltage and the period can be
programmed, how long the boost charge should be activated. After having entered the window by
pressing OK, the first line shows “Boost___voltage“ and you may alter the voltage appearing in the
second line by pressing the arrow keys
▲▼ . By pressing OK, the window “Boost___time“ appears a
you may adjust the time period. Both of these settings are confirmed by OK and stored.
Possibilities for programming: in the period from 00:3
7 ..30,0V |
54,0V...60,0V
The equalisation charging can be programmed similar to adjusting the boost charg
Press OK to enter, edit the equalisation charge voltage by pressing the arrow keys
▲▼
then press OK to edit the adjustable time period, and confirm both settings by pressing OK. The
equalisation charging can only be adjusted for batteries with liquid electrolyte, since high equalizing
voltages are harmful for sealed batteries. The maximum equalizing voltage value should be stated on t
battery manufa turers’ data sheet.
eactivated if you have selected “Fixed“ within the menu CONF (under selection of
electrolyte). Factory Pre-Set Configuration presumes liquid electrolyte batteries. You will find a detailed
description in chapter 6.7.1, page 17
Possibiliti
15