Stanley STGL2218, Руководство пользователя

Страница: 9 / 44

ENGLISH
9
PURPOSE OF DESIGN
This angle grinder is designed especially for grinding.
Do not use sandpaper discs and grinding wheels
other than those with depressed center.
Do not use the tool in wet conditions or
environments in the presence of flammable liquids
or gases.
This heavy-duty angle grinder is a professional
power tool.
Do not allow children to come in contact with this
tool. Inexperienced operators are required to use this
tool under supervision.
Electrical Equipment Safety
Only one voltage is applicable to this tool. Be sure
to check that the power suuply corresponds to the
voltage on the rating plate.
Your Stanley tool is equipped with double
insulation, hence, it does not require to
be earthed.
When the power cord is damaged, have it sent to a
Stanley service center for replacement to specially
prepared cables.
Using Extension Cords
If an extension cord is required, please select a
3-phase extension cord that has been inspected
and matches the input power (see Technical Data) of
this tool. The minimum conductor size is 1.5mm2,
maximum length is 30 meters.
When using a cable reel, be sure to pull out all the
cables.
Assembly and Adjustment
WARNING: To minimize the danger
of serious personal injury, please
switch off the tool power and
disconnect all plugs before adjusting
or removing/installing any accessory.
Before reassembling the tool, press and
release the trigger switch to make sure
the tool is already switched off.
Attaching and Removing the Wheel
Guard (Fig. B)
WARNING: To minimize the danger
of serious personal injury, please
switch off the tool power and
disconnect all plugs before adjusting
or removing/installing any accessory.
Before reassembling the tool, press and
release the trigger switch to make sure
the tool is already switched off.
ATTACHING THE GUARD
1. Place the angle grinder on a work bench,
groove facing up.
2. Bring the flange of the guard (3) collar over the
groove (11) of the gear housing.
3. Turn the guard (4) counterclockwise by 150
degrees.
4. Make sure that the screws (20) are tightened.
REMOVING THE GUARD
1. Loosen the screws (20) on the guard collar.
2. Pull up the guard (3).
WARNING: Do not operate the tool
when the safety guard is not in place.
Fitting and removing a grinding
(Fig. C1, C2, C3)
WARNING: Do not use damaged
grinding wheels.
1. Place the tool on a work bench, guard up.
2. Fit the inner flange (6) correctly onto the spindle
(7) (Fig. C1).
3. Place the disc (8) on the flange (6) (Fig.C2).
When fitting a disc with a raised center, make
sure that the raised centre (9) is facing the
flange (6).
4. Screw the out flange (10) onto the spindle (7)
(Fig. C3)
- the ring on the flange (10) must fae towoards the
disc when fitting a grinding disc (A)
- the ring on the flange (10) must face away from the
disc when fitting a cutting disc (B)
5. Press the spindle lock (2) and rotate the
spindle (7) until it locks in position (Fig. C2).
6. Tighten the flange (10) with the two-pin spanner
supplied.
7. Release the spindle lock.
8. To remove the disc, loosen the flange (10) with
the two-pin spanner.
WARNING: Do not use a damaged disc.
Mounting the side handle (Fig.D)
• For grinding, screw the side handle (4) tightly