Stanley SCD121, Руководство пользователя

Страница: 6 / 24

6
ENGLISH (
Original Instructions)
especially oak, beech and MDF.)
ELECTRICAL SAFETY
The electric motor has been designed for one voltage only.
Always check that the battery pack voltage corresponds
to the voltage on the rating plate. Also make sure that the
voltage of your charger corresponds to that of your mains.
Your STANLEY charger is double insulated in
accordance with EN 60335; therefore no earth
wire is required.
• If the supply cord is damaged, it must be replaced by a
specially prepared cord available through the STANLEY
service organisation.
USING AN EXTENSION CABLE
An extension cord should not be used unless absolutely
necessary. Use an approved extension cable suitable for
the power input of your charger (see Technical Data). The
minimum conductor size is 1 mm2; the maximum length is
30 m.
When using a cable reel, always unwind the cable
completely.
IMORTANT SAFETY INSTRUCTIONS FOR ALL
BATTERY CHARGERS
Save these instructions: This manual contains important
safety and operating instructions for SC122 battery charger.
• Before using charger, read all instructions and
cautionary markings on charger, battery pack, and
product using battery pack.
WARNING: Shock hazard. Do not allow any
liquid to get inside charger. Electric shock may
result.
CAUTION: Burn hazard. To reduce the risk
of injury, charge only STANLEY rechargeable
batteries. Other types of batteries may burst
causing personal injury and damage.
CAUTION: Children should be supervised to
ensure that they do not play with the appliance.
NOTICE: Under certain conditions, with the charger plugged
in to the power supply, the charger can be shorted by foreign
material. Foreign materials of a conductive nature such as,
but not limited to, grinding dust, metal chips, steel wool,
aluminum foil, or any buildup of metallic particles should be
kept away from charger cavities. Always unplug the charger
from the power supply when there is no battery pack in the
cavity. Unplug charger before attempting to clean.
• DO NOT attempt to charge the battery pack with any
chargers other than the ones in this manual. The
charger and battery pack are specifically designed to
work together.
• These chargers are not intended for any uses other
than charging STANLEY rechargeable batteries. Any
other uses may result in risk of fire, electric shock or
electrocution.
• Do not expose charger to rain or snow.
• Pull by plug rather than cord when disconnecting
charger. This will reduce risk of damage to electric plug
and cord.
• Make sure that cord is located so that it will not be
stepped on, tripped over, or otherwise subjected to
damage or stress.
• Do not use an extension cord unless it is absolutely
necessary. Use of improper extension cord could result
in risk of fire, electric shock, or electrocution.
• Do not place any object on top of charger or place
the charger on a soft surface that might block the
ventilation slots and result in excessive internal
heat. Place the charger in a position away from any
heat source. The charger is ventilated through slots in
the top and the bottom of the housing.
• Do not operate charger with damaged cord or plug
— have them replaced immediately.
• Do not operate charger if it has received a sharp
blow, been dropped, or otherwise damaged in any
way. Take it to an authorised service centre.
• Do not disassemble charger; take it to an authorised
service centre when service or repair is required.
Incorrect reassembly may result in a risk of electric
shock, electrocution or fire.
• In case of damaged power supply cord the supply cord
must be replaced immediately by the manufacturer, its
service agent or similar qualified person to prevent any
hazard.
• Disconnect the charger from the outlet before
attempting any cleaning. This will reduce the risk
of electric shock. Removing the battery pack will not
reduce this risk.
• NEVER attempt to connect 2 chargers together.
• The charger is designed to operate on standard
household electrical power. Do not attempt to use
it on any other voltage. This does not apply to the
vehicular charger.
Charger
The SC122 charger accept 12V Max / 10.8V Li- Ion
batteries. The charger require no adjustment and are
designed to be as easy as possible to operate.
LABELS ON TOOL
The following symbols are shown on the tool along with the
date code:
WARNING! To reduce the risk of injury, the user
must read the instruction manual.
Always wear safety goggles
Always wear safety hearing protection
n
Visible radiation. Do not stare into light.
Position of date code
The Date Code, which also includes the year of manufacture,
is printed into the housing.
Example:
2021 XX JN
Year of manufacturing