204038
Rev. B, 4/12/08
© 2008, THE STANLEY WORKS. ALL RIGHTS RESERVED.
6 of 17
3.3.2
INSTALL rotary key switch assembly as follows:
•
If installation is a Dura-Glide 3000, Refer to 203926, “Rotary/Key Switch
Instruction Manual,” for machining template and MOUNT rotary function key
switch assembly to header cover.
•
If installation is a Dura-Glide 2000, Refer to 203926,“Rotary/Key Switch
Instruction Manual,” for machining template and MOUNT rotary key switch
assembly to header or jamb inside of building.
3.4
Installing the 4-Contact Plate Assembly ( P/N: 516908) for Biparting Doors
3.4.1
Refer to Figure 3, and INSTALL the 4-contact plate assembly as follows:
a.
CLOSE the two doors, and ENSURE that the doors close at the center of the header.
b.
MARK the center of the header onto the back of the header.
c.
POSITION the 4-contact plate onto the header, and MARK the location of the
mounting holes.
CAUTION
The two top mounting holes for the 4-contact plate assembly are located above the track tube. When
drilling these two holes, use caution to ensure that the drill bit does not nick the wires located in the header
track.
d.
DRILL the four mounting holes for #8-18 self-tapping screws.
e.
ROUTE the 4-contact plate wire harness to the inside of the header.
f.
Using the four screws provided, FASTEN the 4-contact plate to the header.
Figure 3. Installing the 4-Contact Plate Assembly for Biparting Doors
HEADER
PANEL
PANEL
4 CONTACT PLATE
MARK HOLES. USE # 29
DRILL
CENTER OF HEADER
HEADER
MARK HOLES. USE #29 DRILL
4-CONTACT PLATE
PANEL
PANEL
DE007
