Stairmaster Crossrobics 1650 LE, Руководство пользователя

Страница: 57 / 108

Page 48
PARTS REMOVAL AND REPLACEMENT
ALTERNATOR
1. Unscrew the DC power cable from the connector located inside the
lower corner of the right rear cover.
2. Remove the left side cover.
3. Note the origin and color of each wire at the alternator terminals (see
Wiring Diagram 1). Remove the wires.
4. Remove the alternator Poly-V belt.
5. Remove the nut at the frame pivot and the bolt at the brace (see
Figure 31).
6. Remove the alternator.
7. To install the new alternator, reverse these procedures. The alternator
Poly-V belt is tensioned properly when the center of either side of the
belt can be deflected 1/4" (0.6 cm) from its center line with fingertip
pressure (see Figure 10).
8. Connect the DC power cable before you install the side cover. If the
console does not power up, check your wiring against the Wiring
Diagram 1.
9. If the console powers up, reattach the side cover.
ALTERNATOR POLY-V BELT
1. Remove the seat and seat tray.
!
WARNING
THE BELTS MUST BE TENSIONED SO THAT THE CENTER OF EITHER SIDE CAN BE
DEFLECTED 1/4" (0.6 CM) FROM ITS CENTER LINE WITH FINGERTIP PRESSURE.
A TIGHT BELT MAY CAUSE SLOW AND SLUGGISH OPERATION;
A LOOSE BELT WILL CAUSE EXCESSIVE NOISE AND BELT WEAR.