Stairmaster Crossrobics 1650 LE, Руководство пользователя

Страница: 14 / 108

Page 5
The StairMaster ® Crossrobics ® 1650 LE exercise system must be placed on a
solid, level surface near an AC wall outlet. A minimum ceiling height of 6.5
feet (1.98 meters) and a doorway width of 34 inches (86 cm) is required.
Upon delivery, the shipping representative of StairMaster Health &
Fitness Products, Inc. will place your new StairMaster Crossrobics 1650 LE
conditioning system wherever you designate in your facility. The machine
requires minor assembly. Machines shipped outside the United States may
require additional assembly; refer to the International Installation Instruction
Sheet for details. To install the machine, perform the following steps:
1. Once the machine is in the desired location, remove the shipping
casters and place the rubber end caps onto the frame.
2. Connect the DC power cable to the machine at the connector located
inside the right rear cover of the machine.
3. Place the power supply on the floor near an AC wall outlet.
4. Check to be sure that the input AC power rating marked on the
power supply matches the available power. If it does not, obtain the
matching power supply from StairMaster Health & Fitness Products,
Inc. before proceeding any further.
5. Connect the AC power cord to the AC wall outlet. Refer to the
"Grounding Instructions" section if the AC wall outlet does not accept
a three-prong plug.
INSTALLATION INSTRUCTIONS
TO PREVENT TIPPING THE MACHINE, AND TO REDUCE THE CHANCES OF INCURRING
A FOOT INJURY, REMOVE ALL SHIPPING CASTERS AND PLACE THE RUBBER END
CAPS ONTO THE FRAME BEFORE OPERATING THIS EQUIPMENT.
!
WARNING