Stairmaster Crossrobics 1650 LE, Руководство пользователя

Страница: 72 / 108

Page 63
PARTS REMOVAL AND REPLACEMENT
4. Slide or gently tap the pedal arm off the mounting post.
5. Remove the master link from the pedal arm chain connection.
6. Clean the pedal arm mounting post before reassembling. DO NOT
SAND THE SHAFT.
7. To reinstall the pedal arm, reverse these procedures.
8. Adjust the shock mounts so that both pedals are lined up (refer to the
shock mount section).
PEDAL ARM CHAIN
1. Remove the left side cover (and the right rear cover if necessary).
2. While an assistant supports the pedal arm, detach the pedal arm
spring from the frame.
3. Lift the pedal arm chain off the clutch sprocket. Lower the pedal arm
to the floor.
4. Remove both master link retaining plates using a standard screw-
driver (see Figure 21). Use the flat of the screwdriver to push the
retaining plate off the pins.
5. To reinstall the chain, reverse the procedures.
6. Lubricate the chain before reattaching the cover(s).
!
WARNING
TO REDUCE THE RISK OF EYE INJURY, WEAR EYE
PROTECTION WHEN REMOVING SNAP RINGS.