Stairmaster Crossrobics 1650 LE, Руководство пользователя

Страница: 76 / 108

Page 67
PARTS REMOVAL AND REPLACEMENT
5. Remove the other guide rod and take out the plate. Pivot the new
plate into place and reinstall the guide rod.
6. Reinstall the weight stack cover.
WEIGHT STACK BELT
1. Remove the left and right side covers and the outside weight stack
cover.
2. Lift the top three weight plates four to five inches above the fourth
weight plate. Insert the weight stack pin through the hole in the fourth
plate and through a hole in the selector rod to create slack in the
weight stack belt.
3. Use two wrenches to loosen the four nuts on the weight stack belt
connector plates at the weight stack end (see Figure 16).
4. Pull the belt from the frame junction to remove the belt from its track
(see Figure 17).
5. Loosen the four bolts on the connector plate at the frame junction of
the belt. Remove the old belt.
6. Insert ~1" (2.5 cm) of the new belt in between the plate and the frame
at the frame junction. Tighten the bolts securely and evenly; the
plates should be parallel.
7. Thread the belt over the floating pulley assembly idler pulley and
under the next idler pulley. The belt goes between the retaining pins
and the pulley (see Figure 17).
8. Push the belt through the belt guard tube. Thread the belt under the
next idler pulley (and between the retaining pin).
9. Insert ~1" (2.5 cm) of the new belt in between the weight stack
connector plates. Tighten the nuts securely, but make sure the gap
between the plates is parallel.