Stack ST8302, Руководство пользователя

Страница: 58 / 81

Chapter 4. Installation STACK ST8302 and ST8360 Video-Logger System
52 User Guide
Wheel speed
sensor
When you have chosen a suitable location for the sensor:
1.
Make a suitable rigid bracket to support the sensor and attach it to
the vehicle and the sensor to the bracket. Do not fit the sensor too
tightly – 1.2 Nm (12 kgf.cm or 0.9 lbf.ft) is ideal. Use fibre washers to
insulate the sensor from heat transmitted through the bracket.
2. The gap between the sensor and ferrous targets should be between
0.5mm and 1.5 mm (0.020 inches-0.060 inches). Ensure that no other
objects pass within 4 mm (3/16 inch) of the sensor when the wheel
rotates.
3. Attach the wire labelled ‘WS’ in the sensor harness to the sensor at
the 4-way ‘Sure-Seal’ connector. Take care to assemble and orientate
this sensor correctly. Press the two halves of the connector together
securely to ensure a waterproof seal.
If for any reason you are unable to use this sensor, Stack offers other
models which may be suitable. Contact Stack for further details.
Diagram 18 –
Location of the
wheel speed sensor