ST ST7 Series, Руководство пользователя

Страница: 262 / 317

262/317
9 - A Carrier-current System for domestIc Remote Control
while ( CycleNumber != 0 ) ; /* wait for end of transmission */
while ( Debounce () != 0 ) ; /* wait for all buttons released */
}
}
Only those lines that are not self-explanatory have been commented.
9.2.3.2 Timer A Capture interrupt service routine
There are two different capture events that can occur for each timer. However, these events
share the same interrupt vector, so that the same interrupt service routine is called for either
event. The first task of the service routine is to determine which event produced the interrupt.
The common Timer A interrupt service routine.
Here is the code of the interrupt service routine:
#pragma TRAP_PROC SAVE_REGS
void TimerAInterrupt ( void )
{
WDGR = 0xFF ;
/* reload watchdog */
if ( TASR & ( 1 << ICF1 ) ) /* Determine which interrupt cause. */
{ /* This is a pseudo-capture 1 interrupt */
TAOC2HR = TimerAPeriod >> 8 ; /* Set new period as calculated
in the capture */
TAOC2LR = TimerAPeriod & 0xff ; /* interrupt service function.
High *MUST* be written first.
*/
asm
{
ld a, TAIC1LR ; /* Dummy read to clear interrupt request */
}
if ( CycleNumber != 0 ) /* transmission is in progress if
not zero */
{
if ( Phase == 0 )
SendOneFrameElement () ; /* Change element every 3
interrupts. */
Phase++ ; /* increment phase for next time */
if ( Phase > 2 )
Phase = 0 ;
/* 0, 1, 2, 0, 1, 2 ... */
}
}
else
{ /* This is a capture 2 interrupt. */
PhaseLockedLoop () ;
/* The interrupt request is cleared there by the read at TAIC2LR */
}
}