© 2009 SpinetiX S.A. All rights reserved.
26
button. If not, reboot the unit by keeping pressed the push-button for few
seconds.
If the green led is blinking fast (several times per second) then your HMP100 unit is in
recovery mode
. In this case, unplug and power up again the HMP100 unit. Wait about 1
minute to complete the booting procedure and check the led again. If the HMP100 unit
remains in recovery mode then contact support.
2) Wrong IP address
In the case where your HMP100 unit has been configured with a wrong IP address and
cannot longer be contacted, you need to reinitialize the unit to its factory default (
See
Reset to Factory default
) and restart the configuration procedure.
Configure the network connection of your PC
Under Windows XP Professional you can configure the network connection of your PC so
as to connect to a HMP100 unit in its default configuration with the following steps:
1) Open the Control Panel (Start>Control Panel) and then double click Network
Connections.
2) Select the local connection corresponding to the RJ-45 Ethernet connection you have
connected to the HMP100 unit. Right click on the icon and choose Properties.
