© 2009 SpinetiX S.A. All rights reserved.
22
You are probably using a VGA cable and your screen is not detected by the
HMP100. Go to the HTTP configuration interface, and under the "
Display Settings
"
page, set "
Power mode for VGA output
" to "
Always On
".
4.
Nothing happens when the push button is pressed.
Make sure that the firmware 2.1 or above is installed on your device. The
firmware version is displayed on top of the "
Firmware Update
" page of the HTTP
configuration interface.
5.
Pressing the push button makes the HMP100 reboot.
Make sure you press only briefly the push button. Pressing the button for more
than 1s, will cause the player to reboot.
Automatic DHCP configuration
This section explains how to manually configure an HMP100 unit to connect to a specific
network using DHCP for the attribution of network addresses. Note that this procedure
assumes that you can access the HTTP server of the HMP100 unit through the Ethernet
interface.
1) Access
the HTTP server of your HMP100 unit.
If you have just received an HMP100 unit see the Get Connected guide to learn
how to connect to its HTTP server
If the network configuration of your HMP100 unit has already been modified follow
the suggestions in Access HTTP server.
2) Select
the Network configuration page on the left menu under Basic. (see screenshot
below)
Under Current settings you can read the current network configuration of the
HMP100 unit. In particular you can read the current IP address, the Host name
and the MAC address.
Under Change settings you can configure the network settings of the HMP100
unit.
3) Configure
the HMP100 to use DHCP.
Set the DHCP radio button instead of Static one.
5) Validate
the changes.
Validate the new network configuration with the Update button.
The changes will be valid once the HMP100 unit has rebooted. If you want to
immediately reboot the unit, check the Reboot now check box before pressing the
Update button.
6) Re-connect
to your HMP100.
You can access your HMP100 using the following address
http://spx-hmp-[serial_number].local/.
If you need to find the IP address assigned to your HMP100. This can be done
using HMD or any of the Bonjour plug-in or applications.
