© 2009 SpinetiX S.A. All rights reserved.
20
a.
IP address: 192.168.1.9 (or any other free address in the 192.168.1.1-
192.168.255.254 range, except 192.168.1.10).
b.
Sub net mask: 255.255.0.0
c.
Default gateway: none
d.
DNS server: none
5.
Validate
that the above steps are successful:
a.
Make sure that HMP100 has completed the booting phase: allow about 1
minute from the HMP100 power up. If you have connected HMP100 to a
display you should see the default animated logo.
b.
Check that the LED is blinking green once per second. If this is not the case go
to the troubleshooting section at the end of this guide.
c.
Open a Web Browser (e.g. Internet Explorer, Firefox...) and type
http://192.168.1.10
in the location bar at the top.
The browser should connect to the HMP100 HTTP server and display the following page.
Checking the HMP100 configuration
This section explains how to use the push button to print the HMP100 configuration on
the screen attached to the player.
Requirements:
One HMP100 unit
o
With firmware 2.1 or above. See
Updating Firmware
to make sure you
have the latest firmware installed.
A screen connected to the HMP100 using VGA, HDMI or DVI
