118153-001 Rev. B
8
3.3.1
Ethernet Cabling
Category 5 (CAT5) Ethernet patch cables are used to connect the uX to the host
computer. There are two ways to connect to the uX via Ethernet: the first is to
directly cable between the host and the uX, and the second is through the use of
a switch, hub, or network.
A direct connection requires a non-standard cable where the wires are not run
straight through. Please refer to the two cable ends shown below in.
Crossover Cable for Direct Connection
A standard connection through a hub, switch, or network uses a standard CAT5
patch cable. Please refer to the two cable ends shown below in figure 8.
Standard Straight Through Cable – Standard CAT5 Patch
Содержание uX SERIES
