Spedo 2600, Руководство по обслуживанию

Страница: 51 / 55

51 - Spedo 2600 Service Manual SP 007 011
Section 6b – OMR sensor set up (continued)
7. If the position of the OMR sensor needs adjusting, loosen the two screws on either end of
the OMR sensor mounting bar (Fig. 8). You can now adjust the OMR sensor backwards and
forwards in the slots to achieve the correct measurement of 14 ½” (+/- 1/16”).
NOTE when
adjusting the OMR mounting bar position, make sure you maintain the gap between
the sensor deflector plate and the intake plate. The measurement should be 1.5mm or
1/16” which is the approximate thickness of a standard steel rule
. (Fig. 6)
8. Disconnect from the mains power.
9. Refit both service doors prior to testing. WARNING Make sure that the mains power is
disconnected prior to refitting the doors. The machine may be become operational
before both service doors guards are in place.
Section 7 – Trouble shooting guide
The table below shows some of the most commonly reported faults and their possible causes.
Before fault finding we advise all settings on the machine are returned to standard, also the machine
is isolated from other equipment.
WARNING The machine must be isolated from its power supply before starting any of the
following procedures.
Description of fault Possible cause
Form keeps wrecking
•
Paper guides are missing
•
Incorrect height on the form guide flap
•
A form jammed in the kick out section
•
Edge trimmer drive belts are worn
•
In feed brush is worn
•
Blade sensor mistimed
Edges of the form are rough
•
Edge trimmer blades are worn
•
Friction hubs worn
•
Edge trimmer belts worn
End of the form are rough
•
Cross cut blades are worn
•
Cross cut blades are out of adjustment
The cut form is not square
•
Cross cut blades are out of alignment
•
Tracking setting incorrect on the pressure head
•
Camber setting incorrect on the pressure head