Spedo 2600, Руководство по обслуживанию

Страница: 26 / 55

26 - Spedo 2600 Service Manual SP 007 011
Section 3c – Blade guide preparation (continued)
1. Loosen the grub screws which hold the blade guide eccentrics. (Fig. 1) There are two
eccentrics, one at each end of the blade guide.
2. Insert a bar into the hole through the blade guide eccentric, move the eccentric towards the
blade mount. (Fig. 2) Once clear apply some HMP grease to the end of the blade guide
eccentric. (Fig. 3)
This should be carried out for both eccentrics.
3. Re-insert the blade guide eccentric into the blade guide. Reset the position of the eccentric
by rotating it towards the rear of the machine at about 45 degrees from vertical. (Fig. 4)
This
should be carried out for both eccentrics.
4. Check the blade guide’s lateral position by measuring from the end of the guide, to the
inside edge of the blade mount. The gap both ends should be approximately the same +/-
1mm. (Fig. 5 & 6) If this has been done correctly the upper cross cut blade backstop will sit
approximately central in the relief in the front blade guide.(Fig. 7)
5. Remove the upper cross cut blade oil wick. (Fig. 8) Oil the surface of the front blade guide
with a small amount of light machine oil. (Fig. 9) Then using a circular motion with a
medium grade oil stone, hone the surface of the front blade guide. (Fig.10)
If the surface of
the blade guide is deeply scored then the part must be replaced.
11 12
13 14
15 16