Spedo 2600, Руководство по обслуживанию

Страница: 46 / 55

46 - Spedo 2600 Service Manual SP 007 011
1. Remove the operator side service door. (Fig. 1) This will reveal the blade drive timing
pulley. (Fig. 2)
2. Loosen the screws which hold the blade drive motor. (Fig. 3)
3. Loosen the locking nut and belt tensioner screw; this will slacken the blade drive belt. (Fig.
4)
4. With the blade drive belt tension screw loosened you can lift the blade drive motor, (Fig. 5)
and remove the blade drive belt. (Fig. 6)
5. Fit the new blade drive belt by looping it over the blade motor pulley first, then over the
blade drive timing pulley. (Fig. 7)
6. Tension the blade drive belt using the belt tension adjuster screw, and then once the tension
is set tighten the locking nut. (Fig. 8)
7. Tighten the blade motor into position. (Fig. 9) Check the blade drive belt tension; you
should be able to give the belt a half twist at the centre point of the belt run. (Fig. 10)
Section 5b – Blade sensor setup
5 6
7 8
9 10