Spedo 2600, Руководство по обслуживанию

Страница: 40 / 55

40 - Spedo 2600 Service Manual SP 007 011
1. Loosen the grub screws which locate and adjust the pressure head axle. They are located on
the lower section of the pressure head, one above the axle, (Fig. 1) and one below.(Fig. 2)
2. The axle is removed by pushing it out from the opposite end. You may need to apply a
small amount of pressure, using a pin punch. (Fig. 3 & 4)
3. The pressure wheel can now be removed, complete with the two shims. (Fig. 5 & 6)
NOTE: Care must be taken not to lose the shims as they can easily fall out.
4. Remove the pressure adjuster wheel retaining screw from the top of the pressure head.
(Fig. 7)
5. Loosen the pressure adjuster locking screw from the pressure adjuster wheel. (Fig. 8) You
are now able to unscrew and remove the pressure adjuster wheel. (Fig. 9 ) CAUTION: The
pressure adjuster wheel is under spring pressure – REMOVE WITH CARE
6. With the pressure adjuster wheel removed, (Fig. 10) you can now remove the pressure
release arm. (Fig. 11)
7. Remove the upper section of the pressure head, (Fig. 12) to reveal the pressure head spring.
(Fig. 13)
Section 4f – Pressure head assembly rebuild
9 10
11 12
13