Spedo 2600, Руководство по обслуживанию

Страница: 24 / 55

24 - Spedo 2600 Service Manual SP 007 011
Section 3b – Cross cut blade removal (continued)
1. Remove the air hose (Fig. 1)
2. Loosen the six bolts holding the rear blade guide in place. Holding the guide with one hand,
completely undo each screw in-turn. (Fig. 2) NOTE: All spacers must be retained
3. Holding the upper cross cut blade as shown, loosen and remove the four screws that hold
the blade in position. (Fig. 3) There are two screws each end of the blade. Take care to
retain the two threaded plates which sit behind the blade. (Fig. 4) One plate each end of the
blade. The upper cross cut blade can now be lifted clear of the machine. WARNING Even
blades that have been used may still be sharp so handle with care.
4. Remove the strip cut plate (Fig. 5)
5. Remove the screws which hold in place the kick-out roller assembly, making sure that first
you remove the drive belts. (Fig. 6) Belt removal shown in Section 1a ‘Edge Trimmer Shaft
Removal’ Fig. 2 . Once the assembly is no longer retained, simply remove through the outer
side of the machine. (Fig. 7)
6. Loosen the three nuts which hold the lower cross cut blade. (Fig. 8) The lower cross cut
blade can now be lifted clear of the machine.(Fig. 9) WARNING Even blades that have
been used may still be sharp so handle with care.
7 8
9