Spectracom GSG-5 series, Руководство пользователя с руководством по SCPI

Страница: 37 / 378

Figure 2-9:
Front assembly plate installation Agilent unit (shown left), GSG unit
10.
Install the rear assy plate, Agilent , and the rear assy plate, GSG , and assemble them, as
shown in the illustrations below.
Figure 2-10:
Installation of rear assembly plates
11.
Equivalent to Step 8., install the front panel ear plate (Agilent rack-mount kit) to the Agi
lent power meter.
12.
The assembly is now complete, and can be installed in the cabinet.
2.4 Electrical Installation
Supply Voltage
GSG Series simulators may be connected to any AC supply with a voltage rating of
100 to 240 V , at 50/60/400 Hz . The units automatically adjust themselves to the input line
voltage. The maximum power draw is 40 W.
Fuse
The secondary supply voltages are electronically protected against overload or short circuit.
The primary line voltage side is protected by a fuse located on the power supply unit. The fuse
rating covers the full voltage range. Consequently there is no need for the user to replace the
fuse under any operating conditions, nor is it accessible from the outside.
Caution: If this fuse is blown, it is likely that the power supply is badly damaged.
Do not replace the fuse. Send the GSG unit to your local Service Center.
2.4 Electrical Installation
CHAPTER
2
•
User Manual GSG-5/6 Series Rev. 26
21