Spectracom GSG-5 series, Руководство пользователя с руководством по SCPI

Страница: 36 / 378

5.
Remove the four bottom feet from the housing, as shown in the illustration below:
Use a screwdriver or a pair of pliers to remove the springs holding each foot, then push
out the foot.
Figure 2-8:
Preparing the GSG unit for rack mounting
6.
Gently push the unit into its housing again.
7.
Re-assemble the two rear feet .
8.
Decide on which side of the assembly the GSG unit is to be installed: If on the left-hand
side, install the
short ear to the left hand side of the GSG unit, using the rack-mount kit
M5 housing screws .
Note: The instructions below are based on the assumption that the GSG
unit is installed on the left-hand side of the assembly.
9.
Install the front assy plate to the Agilent unit, as shown in the illustration below. Use the
screws from the Agilent rack-mount kit.
Take two of the
plastic snap caps from the GSG rack-mount kit, remove and discard the
caps, and install the sleeves into the housing screw openings.
Slide the Agilent unit and the GSG unit together, so that the protruding pins of the
front
assy plate fit into the sleeves.
20
CHAPTER
2
•
User Manual GSG-5/6 Series Rev. 26
2.3 Mechanical Installation