Speck pumps badu jet imperial, Руководство по установке

Страница: 17 / 30

17
Final Assembly
1. Insert the o-ring (part# 62) in the jet housing as shown
in Figure 20.
2. Start the ten (10) nozzle housing tapping screws (part#
61) into the pre-assembled nozzle housing (part# 102.1).
Place the nozzle housing at the main jet housing.
3. Feed both lengths of air tubing (part# 47) through the
protective conduit as shown in Figure 20. Allow enough air
tubing to reach the control box and air buttons. Excess can
be trimmed upon installation. Mark each end with a marker.
(P = Pump & L = Light.)
4. Fasten the internal air regulator hose (part# 4) to the hose
nipple inside the jet housing using the hose clamp (part #9).
5. Route the air tubing through the air button openings of
the nozzle housing.
NOTE: Light ON/OFF button is on the
left and the pump ON/OFF button is on the right.
6. Align the complete nozzle housing to the main jet housing
and fasten the ten (10) pre-assembled tapping screws.
All screws should be HAND TIGHT. DO NOT use drills or
pneumatic tools. DO NOT over tighten!
9
47
20
101
116
115
1
102.1
108
61
4
A
A
A
28
113
114
Figure 20
7. Place the anti-entrapment suction cover (part# 93)
against the clamping ring (part# 28) and fasten with four
(4) M8 washers (part# 94) and four (4) M8 x 20 suction
cover screws (part# 95). All screws should be HAND TIGHT.
DO NOT use drills or pneumatic tools. DO NOT over tighten!
Make sure the UP label is in the correct position (
See Figure
21).
WARNING: DO NOT use or operate the BaduJet Imperial if
the anti-entrapment cover is missing, broken, or loose.
8. Align the stainless steel cover (part# 93.1) with
its mounting tabs to the existing notches of the anti-
entrapment suction cover (part# 93). Observe the UP
marking on the stainless steel cover. To fasten the cover
use a screwdriver to bend the two (2) offset tabs outwards
towards the suction housing notches.
(See Figure 21)
9. Guide the air tubing through the two (2) bottom openings
of the light cover (part# 110).
NOTE: Light ON/OFF button
is on the left and the pump ON/OFF button is on the right.
Align the light cover with the nozzle housing and secure
with four (4) light cover tapping screws (part# 112).
(See
Figure 22)
10. Slide one (1) o-ring (part# 37) onto each air button.
Fasten each length of air tubing to the corresponding
buttons using the hose clamps (part# 48). Insert the two
(2) air buttons through the light cover and into the nozzle
housing and lock them by turning them clockwise until they
‘click’ into place.
OBE
N / U
P / HAUT
95
94
93
93.1
OBE
N / U
P / HAUT
A
B
A
B
C
C
D
D
OBENUP
HAUT
Figure 21
Installation of Suction Housing and Stainless Steel Cover