Speck pumps badu jet imperial, Руководство по установке

Страница: 11 / 30

30°
30°
12x3
0° (
=36
0°)
WATER LEVEL
1)
1)
1)
1)
1) Fastening to the formwork (4x)
13.3”
14.0”
1
2.0"
0.3”
~12.0
Gasket with Knobs
Round Sealing Cord
Gunite Cover
Stud & Nut
Formwork
Formwork
Suction connection
Discharge connection UP!
WATER LEVEL
Gunite Cover
~9.4
11
Jet Housing Installation - New Concrete or Gunite Construction - continued
Figure 5
Installation Template for Concrete or Gunite Pools
Figure 6
Installation formwork for Concrete or Gunite Pools
Slide the inner wall formwork over the studs in the
jet housing through the pre-drilled holes. Secure the
formwork to the jet housing with four (4) M8 washers
(part #32) and four (4) M8 nuts (part #33).
n
6. For gunite pools:
7. Pour concrete or apply gunite:
8. Once the concrete or gunite is fully cured and pool wall is
completed, remove the M8 nuts and washers, gunite cover,
and M8 studs. Be sure that the front edge of the jet housing
is flush with the pool wall.
CAUTION: During plastering, the gunite cover, studs,
washers, and nuts should remain installed on the jet housing.
9. Install the clamping ring (part# 28) and stainless steel
handles (part# 70) based on your pool construction:
Mount the gunite cover to the front of the jet housing
using the four (4) M8 x 80mm studs (part #31), four
(4) M8 washers (part #32) and four (4) M8 nuts (part
#33). Tape the edge of the gunite cover around the
entire jet housing to keep gunite out of threaded
inserts and out of the jet housing.
Place the jet housing between the steel rebar. Jet
housing location is very important
(See Figure 6).
n
n
Front edge of the jet housing should finish even with
the inside pool wall. Make sure a V shaped groove is
scraped out around the housing approximately 1.5”
deep to allow marcite to seal against the housing.
Recheck the location of the jet housing when concrete
or gunite is being applied. Make sure the jet housing
remains properly aligned and level.
To avoid stress on the housing, the jet housing and
2 to 3 inches of plumbing/conduit stub out may be
encased in gunite or concrete.
Store all parts not being used now in original box. Store
in a safe place until needed.
n
n
n
n
Gunite wall (no tile or liner):
Align the stainless steel handles (part# 70) and
clamping ring (part# 28) as shown in Figure 7. Use
the twelve (12) M8 x 30 clamping ring screws (part#
52) to attach the clamping ring and handles to the jet
housing.
n