Speck pumps badu jet imperial, Руководство по установке

Страница: 15 / 30

15
Jet Housing Installation - Liner and/or Fiberglass Pool Construction - continued
1)
12x30°(360°)
1) Fasten to clamp ring (12x)
12.0"
WATER LEVEL
0.3”
14.0”
13.3”
15°
Figure 12
Template for fiberglass/vinyl liner pools
6. Align the stainless steel handles (part# 70) over the
clamping ring gasket.
7. Align the clamping ring (part# 28) over the stainless
steel handles (part# 70) as shown in Figure 7.
8. Install the twelve (12) M8 x 30 clamping ring screws
(part# 52).
9. Follow steps 1-4 under Jet Housing Installation - New
Gunite or Concrete Construction on page 9-10.
10. Continue to Final Assembly Section on page 17.
NOTE: The gunite cover (part# 30), M8 x 80 studs (part# 31),
8.4mm washers (part# 32), and M8 nuts (part# 33) are used
in those cases where the swimming pool is commissioned
without the final assembly kit being installed.
CAUTION: All screws should be HAND TIGHT. DO NOT use
drills or pneumatic tools. DO NOT over tighten!
52
26
27
28
70
1
Fiberglass pool
98
52
26
27
28
70
1
Liner pool
98
Figure 13
Fiberglass Pool Installation
Figure 14
Liner Pool Installation