Speck pumpen BADU BADUJET Turbo Pro, Перевод оригинального руководства по эксплуатации

Страница: 32 / 50

Installation
32 EN 08|2020
WARNING
Risk of electric shock due to incorrect connections!
 Electrical connections must always be carried out by
authorised specialists.
 Observe VDE and utility company regulations.
 Install system for swimming pools and their protection areas
in accordance with DIN VDE 0100-702.
WARNING
Risk of electric shock due to voltage on the housing!
 An overload switch which is set correctly must be installed for
pumps with three-phase motors without motor protection. In
doing so, observe the values on the motor name plate.
 Install a disconnecting device with at least a 3 mm contact
gap per pole to interrupt the power supply.
 Protect the circuit with a fault current circuit breaker, all
current-sensitive type B, rated error current I
FN
≤
30 mA.
 Only use suitable pipe types according to regional
regulations.
 Adjust minimum diameter of the electrical pipes to
accommodate the motor output and pipe length.
 Do not bend or squash the pipes.
 If hazardous situations can occur, provide an emergency off
switch according to DIN EN 809. The builder/operator must
make a decision according to this standard.
 The included cables are not approved for laying in the
ground. The conduit FFKuS-EM-F 25 or, for easier pull-
through possibility, FFKuS-EM-F 32 is recommended. These
should also be used for casting in concrete.
5.4.1 Electrical connection of the countercurrent system
 The circuit is partially wired ready for connection. The
connections that are still missing must be made by the
customer.
 The frequency converter may only be mounted at the
available bore holes.
On-site connection:
• Fault current circuit breaker I
FN
≤
30 mA, all current-sensitive
type B