South Bend Tools SB1007, Руководство пользователя

Страница: 61 / 84

South Bend Tools
For Machines Mfd. Since 12/21 Model SB1007
-59-
S E R V I C E
Compound Rest Gib
Tools Needed: Qty
Hex Wrench 2.5mm ..............................................1
Open-End Wrench 8mm ......................................1
To adjust compound rest gib:
1.
DISCONNECT LATHE FROM POWER!
2.
Loosen jam nuts on four set screws shown in
Figure 90.
3. To tighten compound rest gib, tighten set
screws. To loosen gib, loosen set screws.
Note: Be sure to adjust all set screws the
same. This will ensure even wear of gib and
sliding surfaces.
4. Using handwheel, move table back and forth,
repeating adjustments as necessary, until
compound rest movement is acceptable.
5. Hold set screws in place and retighten jam
nuts.
Cross Slide Gib
Tools Needed: Qty
Flat Head Screwdriver #2 .....................................1
To adjust cross slide gib:
1. DISCONNECT LATHE FROM POWER!
2. To increase slide tension, loosen rear gib
screw
1
⁄
8
turn, and tighten front gib screw
1
⁄
8
turn (see Figure 91).
To decrease slide tension, loosen front gib
screw
1
⁄
8
turn, and tighten rear gib screw
1
⁄
8
turn.
3. After each adjustment, use cross slide
handwheel to test cross slide movement.
4. Repeat process until cross slide movement is
acceptable.
Figure Figure 90. Compound rest gib components. . Compound rest gib components.
Set Screws Set Screws
Figure Figure 91. Cross slide gib components. . Cross slide gib components.
Gib Screw Gib Screw
(1 of 2) (1 of 2)