6-5 (E)
UP-CX2
4. Ink Ribbon or Paper Roll Empty
Occurrence event: Displayed when the amount of the remaining ink ribbon is zero or when print paper
was used up.
Detection block: Ribbon tag (ink ribbon) and paper FG sensor (SE-1056 board)
Contents:
The remaining amount of the ink ribbon written in a ribbon tag became zero.
During paper load, paper is not transported to a PJ or PE sensor.
During print operation, paper is not transported to the print start position.
During paper eject, print paper is used up and cannot be cut or paper is not transported
to the next print start position.
Possible cause 1: The remaining amount of the inserted ink ribbon became zero.
Possible cause 2: Defective or dirty PE sensor (PE-42 board) and PJ sensor (PE-44 board)
Possible cause 3: Defective paper FG sensor
Possible cause 4: Dirty or worn roller for transporting print paper or defective block around a roller
Possible cause 5: Defective stepping motor or drive block
Error Log:
Not recorded.
5. Ribbon Cartridge & Paper Size Mismatch
Occurrence event: Displayed when the print size of the set ink ribbon does not coincide with the size of
print paper.
n
For the ribbon of 2UPC-C53 (3.5
x
5 inches) and 2UPC-C55 (5
x
7 inches), set paper
of 5 inches in width. For the ribbon of 2UPC-C54 (4
x
6 inches) and 2UPC-C58 (4
x
8 inches), set paper of 4 inches in width.
Detection block: PP mode 1 and 2 sensor (PSW-87 board) and ribbon tag (ink ribbon)
Contents:
A failure exists in a detection sensor when an error is displayed even if the correctly
combined ribbon and paper are set.
Possible cause 1: Print size of an ink ribbon and print paper size are inconsistent.
Possible cause 2: Defective PP mode 1 and 2 sensor
Possible cause 3: A cleaning ribbon has been set.
Error Log:
Not recorded.
6. Ribbon Cartridge & Paper Size Change
Occurrence event: Displayed when operation cannot be continued because of the switched print paper and
ink ribbon size.
Possible cause 1: During print from a printer driver, an ink ribbon and print paper that have print size
which differs from the print size set using a driver were set.
Error Log:
Not recorded.
7. Too many printouts or paper scraps
Occurrence event: Displayed when paper scraps may be accumulated in a paper cassette assembly.
n
Paper scraps may not be actually accumulated even if this error is displayed. In this
case, remove the paper cassette assembly once and insert it again for restoration.
Contents:
Paper scraps may be accumulated judging from the number of printing sheets.
Possible cause 1: Paper scraps are accumulated in a paper cassette assembly.
Error Log:
Not recorded.
Содержание UP-CX2
