5-30 (E)
Digital Cinema Dual System
3. Tap
[Distortion|Adjust]
to open the Adjust Distortion screen.
4. Overlay the image of the sub-projector on the image of the main projector.
Adjust the value in the H direction and V direction using the value input box or
[+]
/
[_]
for each
Distortion.
.
Value input box: Type the setting value directly.
.
[+]
:
Setting value is increased.
.
[_]
:
Setting value is decreased.
When
[Reset]
is tapped, all setting values of Distortion are reset to “0”.
Tap the adjustment point. Adjust the H Adjust and V Adjust usng the value input box or
[+]
/
[_]
.
.
Value input box: Type the setting value directly.
.
[+]
:
Setting value is increased.
.
[_]
:
Setting value is decreased.
When
[Reset]
is tapped, all setting values of the adjustment points are reset to “0”.
For details on the adjustment procedure, refer to “Distortion adjustment procedure” described later.
n
If possible, adjust the image only by changing the value of sub-projector without changing the value
of the main projector.
5. Tap
[Close]
to close the Adjust Distortion screen.
Distortion adjustment procedure
Here, about which point of the image projected on the screen to be adjusted using which distortion is
described.
The test signal to be used is Convergence Adjust.
In this test signal, the cyan grid pattern is projected from the main projector and yellow grid pattern is
projected from the sub-projector.
The thick line width of the grid pattern corresponds to approx. 2 pixels and the thin line width corresponds
to approx. 1 pixel.
Screen example
Value input box,
[+]
,
[_]
Value input box,
[+]
,
[_]
Adjustment point
[Reset]
[Reset]
[Close]
Distortion
