21
Chapter 2 Installation
1
Press the power switch on the rear of the library.
The library can only be turned on by pressing the power switch on the rear.
The initialization operations appear
on the LCD display.
When the initialization process
ends, the library enters the time
setting mode.
2
If you want to change the date and
time, press the [ENTER] button. If
you do not want to make changes,
press the [CANCEL] button.
For details about the date and time
settings, see “Setting the Date and
Time” (page 23).
Once the library is started, the
message on the right appears.
3
After pressing the standby switch on the library's front panel, wait at least
15 seconds before turning on the host computer.
Then, go to “Initial Setup” (page 22).
Notes
• If the host computer is turned on too soon after turning on the library, the
host computer may not detect the library's SCSI IDs. Wait at least 15
seconds after turning on the library before turning on the host computer.
• If the library does not work as above, refer to “Troubleshooting” (page
83).
Initialize completed
Inventory 83
Jan/01/2001
12:00:50
See the Date and Time
if necessary
[ENTER] to set
[CANCEL]to exit
READY
AIT2
AIT2
D1
D2
1 2 3 4
5 6 7 8
9 10 11 12
13 14 15 16
