Sony DVW-500/1, Руководство по эксплуатации

Страница: 112 / 169

6-1 Basic Automatic Editing
6-12
Chapter 6 Editing
Chapter 6 Editing
Monitoring signals during editing
During editing, you can monitor the following video
and audio signals on a monitor connected to the
recorder VTR.
• Between preroll and IN points: Playback signal of
the recorder VTR can be monitored.
• Between IN and OUT points: Playback signal of the
player VTR can be monitored in E-E mode.
• Between OUT and post-roll points: Playback signal
of the recorder VTR can be monitored.
The video and audio signals that can be monitored are
shown in the diagram below.
Monitoring signals during editing
In CONFI mode, you can monitor video and audio
signals that are just being edited.
Through a menu setting, you can also monitor signals
between preroll and postroll points, including portions
between IN and OUT points, through the CONFI
(confidence) heads during editing. Set the
[F2]
(CONFI) button in HOME menu to on.
Use 316. CONFIDENCE PB MODE in the VTR
SETUP menu to select the CONFI playback mode.
Monitoring video and audio signals of the
recorder and player VTRs on a single
monitor
The following procedure allows you to perform editing
effectively even when using only one monitor.
1
Connect the recorder VTR to the monitor.
2
Set 008. MONITOR SEL in the VTR SETUP
menu to AUTO.
3
Press the PLAYER button on the recorder VTR to
place the recorder into E-E mode.
Playback signals from the player VTR are output
to the monitor.
Note
Insert editing requires that CTL signals are recorded
onto the tape in the recorder VTR. Any sections of the
tape onto which CTL signals have not been recorded
cannot be used for insert editing.
$ $
PB
(recorder VTR)
IN point
EE
(player VTR)
OUT point
PB
(recorder VTR)