ENGLISH
JAPANESE
ENGLISH
JAPANESE
DSC-H50_L3
1-5. HOW TO WRITE DATA TO INTERNAL MEMORY
Usually, the camera has been set so as to disable the data writing from the PC to the internal memory of the camera.
This setting must be changed temporarily when the data is to be written to the internal memory such as a case after the board replacement.
To change the setting, use the write enable tool “WriteEnableTool.exe”.
Data writing method
1)
Connect the PC to the camera (USB mode: Mass Storage), and switch the driver to the “Sony Seus USB Driver”.
2)
Start the Write Enable Tool and the SeusEX.
3)
Click the
[Activate Write Enable Mode]
button of the Write Enable Tool.
4)
Upon completion of the setting change, the following message will be displayed.
5)
Return the driver to the original one, and connect the PC to the camera (USB mode: Mass Storage).
6)
Write the data read out into the PC to the internal memory of the camera.
7)
Disconnect the PC from the camera, and turn off the camera.
Note:
By turning off the camera, the write enable setting is reset.
1-4
