Sony BVP-550, Руководство по обслуживанию

Страница: 750 / 924

4-40 (E)
BVP-550
9. Confirm that the carrier leakage does not monitored at
portion C on the waveform monitor.
Specifications : C = Minimum
(Waveform Monitor)
File Store:
Execute the file store. Press the MENU SEL switch to
execute.
MENU : Reference File
PAGE : Reference File (R1)
ITEM : File Store
Resetting after Adjustment:
• Set the menu as follows.
MENU : Paint
PAGE : Video Level (P1)
ITEM : Test
→
Off
• WHITE BAL switch (on the side panel)
→
PRST
4-3-16. Flare Adjustment
Equipment : Waveform monitor
Test Point : TEST OUT connector
Object : Grayscale chart
Preparations:
• Connect the waveform monitor to the TEST OUT
connector.
• Shoot the grayscale chart so that the chart frame is
aligned with the underscanned monitor frame.
• RGB/ENC switch (on the side panel)
→
ENC
• Set the DISP switch (on the side panel) to MENU while
holding down the MENU SEL switch (on the front
panel). Set the menu as follows.
MENU : Paint
PAGE : Knee/W.Clip (P6)
ITEM : Knee
→
Off
Iris of the lens
: A = 100
±
2 IRE (for NTSC)
A = 700
±
14 mV (for PAL)
(Waveform Monitor)
Adjustment Procedures:
1. Adjust the auto white balance.
WHITE BAL switch (on the side panel)
→
A
AUTO W/B BAL switch (on the front panel)
→
WHT
2. Open the iris control of the lens by two stops against
the reference setup (corresponding above A).
3. Set the RGB/ENC switch (on the side panel) to ENC.
Set the R/G/B switch (on the side panel) to G.
4. Select the 15 lines in the center of the monitor screen
by using the 15 LINESELECT on the waveform
monitor.
4-3. Overall Electrical Alignment
4-3-15. Gamma Correction Adjustment
4-3-16. Flare Adjustment
Line Select