Sony BVP-550, Руководство по обслуживанию

Страница: 500 / 924

4-10 (E)
BVP-550
3. Set the menu as follows.
MENU : Paint
PAGE : Video Level (P1)
ITEM : Test
→
1
4. Set the RGB/ENC switch (on the side panel) to ENC.
5. Adjust the auto white balance.
WHITE BAL switch (on the side panel)
→
A
AUTO W/B BAL switch (on the front panel)
→
WHT
6. Set the menu as follows, and adjust the gamma
correction for (R) by using the MENU SEL switch.
MENU : Paint
PAGE : Video Level (P1)
ITEM : Gamma [R]
Specifications : Center the beam spot on the
vectorscope.
7. Set the menu as follows, and adjust the gamma
correction for (B) by using the MENU SEL switch.
MENU : Paint
PAGE : Video Level (P1)
ITEM : Gamma [B]
Specifications : Center the beam spot on the
vectorscope.
8. Repeat the steps 6 and 7 alternately, until the beam
spot is minimized on the vectorscope.
(For NTSC)
(For PAL)
(Vectorscope)
9. Confirm that the carrier leakage does not observed at
portion C on the waveform monitor.
Specifications : C = Minimum
(Waveform Monitor)
Resetting after Adjustment:
• Set the menu as follows.
MENU : Paint
PAGE : Video Level (P1)
ITEM : Test
→
Off
• WHITE BAL switch (on the side panel)
→
PRST
4-2. Adjustment for Installation of OHB
4-2-6. Gamma Correction Adjustment
R
M
G
C
Y
G
Y
L
B
R
M
G
C
Y
G
Y
L
B