SonicWALL SuperMassive 9800, Руководство по началу работы

Страница: 49 / 76

SonicWall SuperMassive 9800 Getting Started Guide 49
4 Log into the Secondary SonicWall appliance’s unique
LAN/WAN IP address. The management interface
should now display
Logged Into: Secondary
SonicWall Status: Active
in the upper right ‐
hand corner.
5 Turn the Primary appliance back on.
6 Wait a few minutes.
7 Log back into the management interface. If stateful
synchronization is enabled (automatically disabling
preempt mode), the management GUI should still
display
Logged Into: Secondary SonicWall
Status: Active
in the upper ‐ right ‐ hand corner.
If you are using the Physical/Logical Monitoring feature,
experiment with disconnecting each monitored link to ensure
correct configuration.
Configuring Wire Mode
This section provides an overview of the different types of
Wire Mode supported on the SonicWall SuperMassive 9800
appliance and instructions for how to set up the appliance in
tandem with an existing Internet gateway device. This section
is relevant to administrators following deployment Scenario C:
Wire Mode on page 40 .
Topics:
• Wire Mode Settings on page 49
• About Connections on page 52
• Configuring Interfaces for Wire Mode on page 52
Wire Mode Settings
SonicOS supports Wire Mode on the SonicWall SuperMassive
9800 appliance with these settings:
• Secure Mode on page 49
• Inspect Mode on page 50
• Bypass Mode on page 50
Secure Mode
Secure Mode unleashes the inspection and policy engines’ full
set of capabilities:
• Application Intelligence
and Control
• Gateway and Cloud ‐
based Anti ‐ Virus
• Intrusion Prevention
Services
• Content Filtering
• Anti ‐ Spyware