SonicWALL SuperMassive 9800, Руководство по началу работы

Страница: 66 / 76

66 SonicWall SuperMassive 9800 Getting Started Guide
Safety and Regulatory
Information
Safety Instructions
The following conditions are required for proper installation:
• The SonicWall appliance is designed to be mounted in a standard 19 ‐ inch rack
mount cabinet.
• Use the mounting hardware recommended by the rack manufacturer and
ensure that the rack is adequate for the application.
• Ensure that no water or excessive moisture can enter the unit.
• Allow unrestricted airflow around the unit and through the vents on the side of
the unit. A minimum of 1 inch (25.44mm) clearance is recommended.
• Route cables away from power lines, fluorescent lighting fixtures, and sources
of noise such as radios, transmitters, and broadband amplifiers.
• This product is not intended to be installed and used in a home or public area
accessible to the general population. When installed in schools, this equipment
must be installed in a secure location accessible only by trained personnel.
• Mount in a location away from direct sunlight and sources of heat. A maximum
ambient temperature of 104º F (40º C) is recommended.
• If installed in a closed or multi ‐ rack assembly, the operating ambient
temperature of the rack environment may be greater than the room ambient.
Therefore, consideration should be given to installing the equipment in an
environment compatible with the maximum recommended ambient
temperature.
• Mount the SonicWall appliances evenly in the rack in order to prevent a
hazardous condition caused by uneven mechanical loading.
• Four mounting screws, compatible with the rack design, must be used and
hand ‐ tightened to ensure secure installation. Choose a mounting location
where all four mounting holes line up with those of the mounting bars of the
19 ‐ inch rack mount cabinet.
• A suitably rated and approved branch circuit breaker shall be provided as part of
the building installation. Follow local code when purchasing materials or
components.
• Consideration must be given to the connection of the equipment to the supply
circuit. Appropriate consideration of equipment nameplate ratings must be
used when addressing this concern. Do not overload the circuit.
• Reliable grounding of rack ‐ mounted equipment must be maintained. Particular
attention must be given to power supply connections other than direct
connections to the branch circuits, such as power strips.
• As shipped from the factory this SonicWall product includes two power supplies
for redundant AC power and added reliability. A field conversion is available to
convert to DC mains.
• To disconnect AC power, both power cords must be removed.
• The included power cord(s) are approved for use only in specific countries or
regions. Before using a power cord, verify that it is rated and approved for use in
your location.
• This model is shipped as AC mains configuration using standard 3 conductor
appliance couplers. A field conversion is available to change to DC mains. The
DC mains connector uses terminal posts with the polarity marked.
• To disconnect DC power, an external properly ‐ related disconnect device must
be provided by building or rack installation.
• Do not connect AC configured products to DC mains, and do not connect DC
configured products to AC. Detailed instructions are provided with the DC
conversion kit. Product must be configured as all DC or all AC.
• DC rating includes tolerances. Do not operate product outside of range shown
on product label.
• DC configuration includes input cable with protective earthing conductor
(Green and Yellow wire). This conductor is required to be connected to safety
earth ground of circuit.
Regulatory Model/Type Product Name
2RK04 ‐ 0AD SuperMassive 9800