SonicWALL SuperMassive 9800, Руководство по началу работы

Страница: 52 / 76

52 SonicWall SuperMassive 9800 Getting Started Guide
About Connections
Wire Mode can be deployed on WAN, LAN, DMZ, and custom
zones, except for wireless zones. Both interfaces must be of
the same type, either 1 Gbps or 10 Gbps.
To connect zones:
1 Connect the LAN port of your existing Internet gateway
device to a 1 Gbps or 10 Gbps port on the SonicWall
SuperMassive 9800 appliance.
2 Connect another interface on your SonicWall appliance
to your WAN, LAN, DMZ, or custom zone resource.
Configuring Interfaces for Wire Mode
Wire Mode can be configured on WAN, LAN, DMZ, and custom
zones. Wire Mode is a simplified form of Layer 2 Bridged
Mode, and is configured as a pair of interfaces. In Wire Mode,
the destination zone is the Paired Interface zone. Access rules
are applied to the Wire Mode pair based on the direction of
traffic between the source zone and its paired interface zone.
For example, if the source zone is WAN and the paired
interface zone is LAN, then WAN to LAN and LAN to WAN rules
are applied, depending on the direction of the traffic.
In Wire Mode, you can enable Link State Propagation, which
propagates the link status on an interface to its paired
interface. If an interface goes down, its paired interface is
forced down to mirror the link status of the first interface.
Thus, both interfaces in a Wire Mode pair always have the
same link status.
SonicWall SuperMassive 9800
Third Party Gateway
Custom Zone
(WAN)
Wire Link
SonicWall SuperMassive 9800
CONSOLE
SDHC
MGMT
X23 X21
X20 X6 X4
1GE 10GE
X2 X0
X1 X3 X5 X7
X22
B0
B1
ALARM
TEST
PWR 1 PWR 2
X14 X12 X18 X16 X10 X8
X9 X11 X13 X15 X17 X19
80GB
SSD
80GB
SSD
Internet
NOTE: All Wire Mode interfaces must be configured in
IPv4. Although Wire Mode is supported for IPv6, you
cannot edit Wire Mode settings in IPv6.