SonicWALL SuperMassive 9800, Руководство по началу работы

Страница: 20 / 76

20 SonicWall SuperMassive 9800 Getting Started Guide
The following sections provide initial configuration information
and instructions for connecting your SonicWall SuperMassive
9800 appliance for initial setup.
• Connecting the MGMT Port on page 20
• Applying Power to the Appliance on page 20
• Using the Setup Wizard on page 21
Connecting the MGMT Port
The MGMT port is a dedicated 1 gigabit Ethernet interface for
appliance management and SafeMode access.
1 Using the provided Ethernet cable, connect one end of
the cable to the computer you are using to manage the
SuperMassive 9800 appliance.
2 Connect the other end of the Ethernet cable to the
MGMT port on your SuperMassive 9800 appliance.
The default MGMT port IP address is:
http://192.168.168.168
.
Applying Power to the Appliance
Connect the AC power cords from the SuperMassive 9800
appliance into appropriate power outlets.
For further information regarding power requirements, refer
to Product Safety and Regulatory Information on page 65 of
this document.
SuperMassive LED Activity
The Power LEDs on the front panel illuminate blue when the
appliance is powered on.
The Test LED or Alarm LED may illuminate and blink while the
appliance performs a series of diagnostic tests. When these
LEDs are no longer illuminated and the Power LEDs remain
steadily lit, the SuperMassive 9800 appliance is ready for
configuration. This typically occurs within a few minutes of
turning on the power.
If the Test or Alarm LEDs remain lit after the SuperMassive
9800 has completed powering on, restart the appliance by
disconnecting the power, waiting 1 minute, and then
connecting the power again.
For a connected MGMT or X0 ‐ X7 port, the Link LED for the
port illuminates green or amber depending on the link
throughput speed, indicating an active connection:
• Amber indicates 1 Gbps
NOTE: See also SuperMassive 9800 LED Usage on page
12 and Port Type and LED Usage on page 13 .