User Manual for the Type 8300 Compatt 6
(and Variants)
UM-8300-Compatt 6
Issue B3
5. Lubricate the 2 x O-rings
on the Sensor Endcap
; see
6. Push the sensor endcap fully into the housing.
Note
If any resistance is felt, pull out the sensor endcap and Chassis fully and inspect the housing
for any obstructions.
7. Position the clamp rings in the grooves on the sensor endcap.
8. Slide the rubber bumper stop over the sensor endcap and align the holes in the clamp rings.
9. Secure the clamp rings to the bumper stop
using the bolts, washers and nuts.
10. Tighten the nuts and bolts.
Section 8 – Maintenance
55