SOLZAIMA EARTH 9KW, Инструкция по эксплуатации

Страница: 58 / 119

57
13. Start-up
After loading the pellets into the deposit (see chapter 13), press and hold the ON/OFF
button for 3s, to start the Free Standing Fire. During the lighting phase, the display will
show the message “Ativação” (Activation) until this phase is completed .
The pellets are fed through the supply channel to the burning basket (combustion
chamber), where they will be ignited using a heat resistor. This process may take 5 to
10 minutes, depending on whether the worm screw used to push through the pellets
has been previously filled with fuel or is empty. Once the ignition phase is completed,
the message "On" appears on the display. The heating power can be adjusted at any
time by pressing the power selection button for approximately 1 second. You can select
from the five pre-set power levels that are available. The selected power is indicated on
the display. The initial power status at each start-up will correspond to the power level
set before the last stop.
Important notice: Before starting up the unit, please check to determine
if the deflector plate is in place.
13.1. Stop
The stop sequence of the unit is started by pressing the ON/OFF button for 3 sec.
The display will show
“Desativação” (Disabling) until full completion of this phase.
The extractor will operate until the fume temperature of 64ºC is reached, to guarantee
that all the material has been burnt.
13.2. Turning Off the Unit
The unit should only be disconnected after its full stop. Make sure the “Off” shows on
the display before disconnecting the unit. If necessary, disconnect the power cable
from the mains.