SOLZAIMA EARTH 9KW, Инструкция по эксплуатации

Страница: 91 / 119

90
• Insertable with refill per load drawer.
This charging system can be used with the equipment in operation, but always with
care as you will be close to sources of heat.
To refill the tank open the cargo drawer by pulling the upper grate completely. Pour the
pellets into the drawer and with the aid of the accessory the pellets should be pushed
to the back of the drawer. The pellets will fall into the tank. When the pellets stop
falling and begin to accumulate in the drawer stop loading.
Figure 45 – Drawer for refuelling
• Insertable with top-load refueling.
This top loading system can be used with the equipment in operation because it does
not interfere with the normal operation of the insert and depending on where the
loading mouth is placed it will not be near the heat source, you can observe the
installation of this system in the Point 4. The installation of the equipment is restricted
to the height and distance to install the respective loading mouth. The mouth can be
installed on the right, left, forward or, if possible, evenly distributed through the back
of the equipment. To load the pellets simply open the loading door, the door has stops
that will open the door in a certain position to facilitate loading, causing a ramp effect
for the pellets to enter the tube into the tank. When checking that the pellets are about
to reach the loading mouth, do not put more and you should close the door.