Solavis DKC400Y, Руководство по установке

Страница: 18 / 22

DKC400Y AC Sliding Gate Installation Manual www.solavis.com.au
Copyright © 2008 SOLAVIS
™
Doc: DKC400Y Installation Manual v1.1 page 18 of 22

Both the width and the auto-close function of the pedestrian mode have been
erased.
Cancel the width of pedestrian mode, but keep the auto-close function of pedestrian
mode:

Please turn the second and the third DIP-switch (See Fig.6 terminal 5) to the ON
position.

Press button 4 to open the gate (see Verify open direction section).

Wait for more than 15 sec. Then press the same button/button 4 to stop the gate.

Pause for how long you want your gate to stay open before automatically closing.
The range is between 0-44 seconds.

Then press the same button/button 4 to close the gate.

Press the same button again to stop the gate or let the gate stop at its closed
position automatically if the limit switch is reached.

After this setup is complete, return DIP-switch 3 to OFF position immediately.
Note: the new auto-close time for pedestrian mode has replaced any auto-close time for
pedestrian mode that you might have set earlier.
Keep the width of pedestrian mode but cancel the auto-close function of pedestrian
mode:

Please turn the second and the third DIP-switch (See Fig.6 terminal 5) to the ON
position.

Press button 4 to open the gate (see Verify open direction section).

Wait until the gate travels the distance you want to set for pedestrian mode (the
range is between 0.3m-1.5m or 3-10 sec.)

Press the same button/button 4 to stop the gate.

Wait until the gate closes automatically (45 sec.). Press the same button again to
stop the gate or let the gate stop at its closed position automatically if the limit switch
is reached.

After this setup is complete, return DIP-switch 3 to OFF position immediately.