DKC400Y AC Sliding Gate Installation Manual www.solavis.com.au
Copyright © 2008 SOLAVIS
™
Doc: DKC400Y Installation Manual v1.1 page 17 of 22
Set auto-close function of pedestrian mode:
Please turn the second and the third DIP-switch (See Fig.6 terminal 5) to the ON
position.
Press button 4 to open the gate (see
Verify open direction
section), wait between
3-10 seconds, then press the same button/button 4 to stop the gate.
Now pause for however long you want your gate to stay open before automatically
closing. This is called th
e ‘auto-close time for pedestrian mode’. The range is
between 1-44 seconds.
Close the gate by pressing the same button/button 4.
Press the same button again to stop the gate or let the gate stop at its closed
position automatically if the limit switch is reached.
After this setup is complete, return DIP-switch 3 to OFF position immediately.
The auto-close function of pedestrian mode
has been set
Note:
the new width of the pedestrian mode entry has been re-programmed in the device
and replaced the original width you have set in the
Set width of pedestrian mode
section
earlier.
If you open the gate with button 4, the gate will stop at the position you have set, and after
pausing for the time you have set, it will close automatically.
Cancel both the width and the auto-close function of pedestrian mode:
Please turn the second and the third DIP-switch
(See Fig.6 terminal 5) to the ON
position.
Press button 4 to open the gate (see
Verify open direction
section).
Wait for more than 15 seconds. Then press the same button/button 4 to stop the
gate.
Wait until the gate closes automatically (45 sec.).
Press the same button/button 4 to stop the gate or let the gate stop at its closed
position automatically if the limit switch is reached.
After this setup is complete, return DIP-switch 3 to OFF position immediately.
