Solavis DKC400Y, Руководство по установке

Страница: 16 / 22

DKC400Y AC Sliding Gate Installation Manual www.solavis.com.au
Copyright © 2008 SOLAVIS
™
Doc: DKC400Y Installation Manual v1.1 page 16 of 22

After this setup is complete, return DIP-switch 3 to OFF position immediately.

The auto-close function has now been set.
Cancel auto-close function:

Please turn the second and the third DIP-switch (see Fig.6 terminal 5) to the ON
position.

Press the remote control button (button 1, button 2 or button 3) that has been
programmed to open the gate (see Verify open direction section).

Stop the gate at any position by pressing the same button, wait until the gate closes
automatically (45 sec.).

Press the same button to stop the gate or let the gate stop at its closed position
automatically if the limit switch is reached.

After this setup is complete, return DIP-switch 3 to OFF position immediately. Thus
the auto-close function has been canceled.
Pedestrian mode:
Pedestrian mode can be used to open the gate partially to allow pedestrian traffic to enter.
Set width of pedestrian mode:

Please turn the second and the third DIP-switch (See Fig.6 terminal 5) to the ON
position.

Press button 4 to open the gate (see Verify open direction section), Wait until the
gate travels the distance you want to set for pedestrian mode (the range is between
0.3m-1.5m or 3-10 sec.)

Then press the same button/button 4 to stop the gate, pause for a few seconds and
close the gate by pressing the same button/button 4.

Press the same button again to stop the gate or let the gate stop at its closed
position automatically if the limit switch is reached.

After this setup is complete, return DIP-switch 3 to OFF position immediately.

The width has been set for pedestrian mode.
If you open the gate with button 4, the gate will stop at the position you have set above.