Maintenance
Select
Maintenance
to set the following options:
D a t e a n d T i m e
R e s e t C o u n t e r s
F a c t o r y R e s e t
S W U p g r a d e S D - C a r d
D i a g n o s t i c s
G r i d P r o t e c t i o n
l
Date and Time
: Set the internal real-time clock. If connected to the SolarEdge monitoring portal, the
date and time are set automatically and only time zone should be set.
l
Reset Counters
: Resets the accumulated energy counters that are sent to the SolarEdge monitoring
portal
l
Factory Reset
: Performs a general reset to the default device settings.
l
SW Upgrade SD-Card
: Perform a software upgrade using an SD card.
l
Diagnostics
: Displays the Isolation Status and optimizers status screens. Refer to
www.solaredge.com/files/pdfs/application_note_isolation_fault_
troubleshooting.pdf
l
Standby Mode
: Enables/disables Standby Mode - for remote commissioning.
l
Grid Protection
: Available in specific countries. Enables viewing and setting grid
http://www.solaredge.com/files/pdfs/viewing_grid_
.
Information
Select
Information
to display the following options:
V e r s i o n s
E r r o r L o g
W a r n i n g l o g
H a r d w a r e I D s
l
Versions
: Displays inverter firmware versions:
o
ID
: The inverter ID.
o
DSP 1/2
: The DSP digital control board firmware version
o
CPU
: The communication board firmware version
NOTE
Please have these numbers ready when you contact SolarEdge Support.
l
Error Log
: Displays the last five errors.
l
Warning Log:
Displays the last five warnings.
l
Hardware IDs
: Displays the following HW serial numbers (if exist, and connected to the inverter):
o
ID
: the inverter's ID
o
RGM1
: Modbus meter (with lower Modbus ID)
o
RGM2
: A second external Modbus meter (with the higher Modbus ID)
o
ZB
: Zigbee MAC address
o
Cell
: MEID (CDMA) or IMEI (GSM)
o
WiFi
: Wi-Fi MAC address
Chapter 7: User Interface
SolarEdge
-
StorEdge
-Single
Battery/High
Capacity
Installation
MAN-01-00283-
1.1
51
