Lit. No. 89451, Rev. 05
50
May 15, 2022
5. After the correct security code has been
entered, the power indicator light will change
from rapid flashing to steady ON, indicating
that the snowplow has been successfully
unlocked.
NOTE: If the plow/vehicle electrical connection
is lost or disconnected, the SECURITY GUARD™
system will reset, requiring any control that is
not programmed with the established 4-digit
security code to manually re-enter the security
code to activate the snowplow.
Clearing an Established 4-Digit Security Code
1. Turn the vehicle ignition switch to the "ON" or
"ACCESSORY" position. The control backlight
will illuminate.
2. If the snowplow is locked (the control power
indicator light will be flashing at a fast rate),
unlock the snowplow by following the Manual
Unlock procedure.
3. Move the ON/OFF switch to the "OFF"
position or push the ON/OFF button to switch
the control OFF. Verify that the power indicator
light is OFF.
4. With the control OFF, move the control lever
to the #2 position or press the #2 button four
consecutive times, then move the lever to
the #3 position or press the #3 button four
consecutive times. This sequence (2, 2, 2,
2, 3, 3, 3, 3) will clear the 4‑digit security
code from the SECURITY GUARD system.
The FLOAT light will flash to indicate that the
4‑digit security code was cleared.
NOTE: To enter a new 4-digit security code
see Activation & Establishing a 4-Digit
Security Code.
OPERATING YOUR SNOWPLOW
Содержание 6800LT
Страница 3: ......
