Lit. No. 89451, Rev. 05
16
May 15, 2022
Vehicle application recommendations are based
on the following:
• The vehicle with the snowplow installed must
comply with applicable Federal Motor Vehicle
Safety Standards (FMVSS).
• The vehicle with the snowplow installed
must comply with the vehicle manufacturer's
stated gross vehicle and axle weight ratings
(found on the driver‑side door cornerpost
of the vehicle) and the front and rear weight
distribution ratio. In some cases, rear ballast
may be required to comply with these
requirements. See "Ballast Requirements" in
this section.
VEHICLE APPLICATION INFORMATION
CAUTION
See your SnowEx
®
outlet/website
for specific vehicle application
recommendations before installation. The
Power Match selection system has specific
vehicle and snowplow requirements.
• SnowEx Power Match selection system
is based on available vehicle capacity for
snowplow equipment on a representative
vehicle equipped with options commonly used
for plowing and with 300 lb (136 kg) of front
seat occupant weight.
• Weights of front seat occupants can be
adjusted above 300 lb (136 kg), but vehicle
with snowplow must not exceed vehicle
GVWR or GAWR.
• In some cases there may be additional
limitations and requirements.
•
Installation, modification, and addition of
accessories must comply with published
SnowEx recommendations and instructions.
Available capacity decreases as the vehicle is
loaded with cargo or other truck equipment, or
snowplow accessories are installed.
• If there is uncertainty as to whether available
capacity exists, the actual vehicle as
configured must be weighed.
Содержание 6800LT
Страница 3: ......