Snorkel S3006P, Руководство оператора

Страница: 17 / 25

PUSH PRO -0120843 15
Maintenance
!
Warning
Always block the elevating assembly whenever
it is necessary to perform maintenance while the
platform is elevated.
Use the following procedure to properly position the
safety props:
1. Remove all tools and material from the platform.
2. Using the lower controls, raise the platform until
the open distance on the chassis is wide enough
to position the safety props. Refer to Figure 5.
Figure 5 – Safety Props
3. Rotate the safety props downward from the
storage position to the support position.
4. Remove hands and arms from the scissors area.
5. Lower the platform until the scissors are
supported by the safety props.
Hydraulic Fluid
The hydraulic fluid reservoir is located in the component
tray. Refer to Figure 6.
Figure 6 – Component Tray
Note
Never add fluid if the platform is elevated.
Check Hydraulic Fluid
1. Make sure that the platform is fully lowered.
2.
Visually check to make sure the fluid is within
6 mm (¼″) of the top of the fill hole.
3. If necessary, remove the filler cap and add fluid of
the proper type. Replace the cap making sure it
is tightly in place. Refer to “Specifications” pages
16 to18.
Battery Maintenance
!
Warning
Hazard of explosive gas mixture. Keep sparks,
flame, and smoking material away from the battery.
Always wear safety glasses when working near
the battery. Battery fluid is highly corrosive.
Thoroughly rinse away any spilled fluid with clean
water.
Always replace the battery with a manufacturer
approved replacement.
• Check the battery fluid level weekly, especially if
the machine is being used in a warm, dry climate.
• If electrolyte level is lower than 6 mm (¼″) above
the plates add distilled water only. DO NOT use tap
water with high mineral content, as it will shorten
battery life.
• Keep the terminals and top of the battery clean.
• Refer to the Service Manual to extend battery life
and for complete service instructions.
!
Warning
Always use manufacturer approved replacement
parts.
Battery Charging
Charge the battery at the end of each work shift or
sooner if the battery has been discharged.
Note
: The PUSH series has a built in feature whereby
power is cut to the lift function when the battery level
reaches a manufacturer preset limit, this is to prevent
excessive wear or damge to the battery. The machine
should immediately be placed on charge if this occurs.
!
Warning
Charge the battery in a well ventilated area.
Do not charge the battery when the machine is
near a source of sparks or flames.
Permanent damage to the battery will result if
the battery is not immediately recharged after
discharging.
Never disconnect the cables from the battery when
the charger is operating.
Maintenance
Safety Props
Reservoir Fill Cap