Snorkel S3006P, Руководство оператора

Страница: 18 / 25

16 PUSH PRO -0120843
Keep the charger dry.
1. At the lower controls, turn the control selector
switch to the off position.
2. Open the component tray to access the battery.
Remove the caps from the battery.
3. Visually check the battery fluid level making sure
the level is within 6 mm (¼″) of the bottom of
the filler neck inside each hole. If needed, add
distilled water.
4. Tightly replace the caps on each battery and
replace and latch the battery tray covers.
5. Plug the battery charger into a properly grounded
outlet ( 110 volt AC, 50/60 Hz) using a 3 conductor,
1.5 mm (12 gauge) or larger extension cord. The
extension cord must be as short as possible and
in good electrical condition.
6. Visually inspect the battery charge indicator for
proper charging rate. The LED is visible on the
left side of the lower controls. Refer to Figure 7
for the function of the LED. The battery should be
fully charged when the LED is solid green.
7. Leave the battery charger plugged in until it shuts
itself off.
Figure 7 – Battery Charge Indicator
Note: If the charging cycle exceeds 16 hours without
the battery being fully recharged, unplug the charger
and have the battery checked.
8. After the battery charger turns itself off, it is not
necessary to immediately unplug the extension
cord from the battery charger. The charger will
monitor the charge state of the battery and
recharge them if the voltage drops off.
9. Slide the component tray open to access the
battery. Remove the caps from the battery.
10. Visually check the battery fluid level making sure
the level is within 6 mm (¼″) of the bottom of
the filler neck inside each hole. If needed, add
distilled water.
11. Tightly replace the caps on the battery and close
and latch the component tray.
Inspection and Maintenance Schedule
!
Caution
Frequency and extent of periodic examinations
may depend on national regulations.
The Complete Inspection consists of periodic visual
and operational checks, along with periodic minor
adjustments that assure proper performance. Daily
inspection will prevent abnormal wear and prolong the
life of all systems. The inspection and maintenance
schedule should be performed at the specified intervals
and after prolonged periods of storage before returning
the machine to service. Inspection and maintenance
shall be performed by personnel who are trained and
familiar with mechanical and electrical procedures.
!
Warning
Before performing preventative maintenance,
familiarize yourself with the operation of the
machine. Always block the scissors structure
whenever it is necessary to perform maintenance
while the platform is elevated.
The daily preventative maintenance checklist has
been designed for machine service and maintenance.
Please photocopy the Daily Preventative Maintenance
Checklist and use the checklist when inspecting the
machine.
Inspection and Maintenance Schedule
Standby : LED = Solid red
Charging : LED = Solid yellow
Fully Charged : LED = Solid green
Charging Error : Flashing Red